Home › Everything we make › Hardwood Gates › Bristol
Bristol · South West
Hardwood Gates in Bristol
Driveway and side gates braced to stay square through a wet winter.
- Free measured survey
- Fixed written quote
- Workshop-made, site-fitted
- 10-year workmanship guarantee
- Fully insured
Bristol is a county of dense Georgian and Victorian terraces on steep ground where every floor has a fall. That is exactly the kind of building stock a pair of hardwood gates has to be drawn around, so we allow for it at survey stage rather than on fitting day — walls get checked for wind and plumb, floors for level, and the setting-out is taken from the worst reading, not the best.
How we approach it
The difference between a fitted job and a fitted-looking job is the setting out. For hardwood gates in Bristol we rod the job first, so what arrives on site already accounts for the bows, the skirting and the ceiling line.
How we build it
Timber is chosen for the room it is going into. Painted work is built in tulipwood and moisture-resistant MDF because they hold a crisp arris and take a sprayed finish without grain rise. Where the grain is meant to be seen we use European oak, walnut or ash, with veneers laid so the figure runs continuously across a set of doors.
Finish and materials
Every finished job gets a short handover: what the surface is, how to clean it, and how to adjust a hinge if a door drops after the heating has been on for a season. Adjustment is normal in timber and takes about two minutes once you know which screw to turn.
| Guide price | from £1,450 per linear metre, fitted |
|---|---|
| Lead time | 6-8 weeks from signed drawings |
| Construction | Iroko, stainless ironmongery |
| Survey area | All of Bristol, including Clifton, Bedminster, Redland, Bishopston |
Want a number now? The indicative price tool gives a range in about a minute. A free survey in Bristol turns it into a fixed written quote.
Towns we cover
Other joinery for Bristol
What happens next
Four steps, no surprises
Survey
A joiner visits, measures the opening, checks for level and plumb, and talks through how you want to use the space.
Drawings & quote
You get a setting-out drawing and a fixed written price. Nothing is ordered until you have approved both.
Workshop
Parts are machined, assembled and finished under cover while the site carries on with other trades.
Fit & handover
We fit, scribe, adjust and touch in, then walk you through care and adjustment before we leave.
Straight answers
Hardwood Gates in Bristol — common questions
Will they match my fencing?
We can match the boarding pattern and spacing so the gate reads as part of the run rather than as an insert. Same species matters too, since different hardwoods silver to different greys.
What stops a wooden gate dropping?
Bracing that runs from the bottom hinge upward, so the diagonal works in compression. Run it the other way and it works in tension, the joints open and the gate sags. This is the single most common fault we are called out to.
What ironmongery do you use?
Stainless or galvanised throughout, and sized generously. Gate hardware fails long before the timber does, and undersized hinges on a heavy hardwood gate will tear out.
How wide can a single leaf be?
Around 1.2 metres before the leverage starts working against you. Beyond that a pair is better than one very wide leaf, both for the hardware and for the swing space.
Do you work with architects and builders?
Regularly. We can work to your drawings and specification, price from a schedule, and co-ordinate with the main contractor's programme. We are equally happy dealing directly with a homeowner from a rough sketch.
Start with a measurement
Tell us the space in Bristol — we’ll tell you what it costs
Every quote starts with a free measured survey, so the price you get is the price you pay. No deposit is taken until you have drawings you are happy with.