Home › Everything we make › Hardwood Gates › North Yorkshire
North Yorkshire · Yorkshire
Hardwood Gates in North Yorkshire
Driveway and side gates braced to stay square through a wet winter.
- Free measured survey
- Fixed written quote
- Workshop-made, site-fitted
- 10-year workmanship guarantee
- Fully insured
North Yorkshire is a county of limestone and sandstone cottages, Georgian York townhouses and rural farmhouses. That is exactly the kind of building stock a pair of hardwood gates has to be drawn around, so we allow for it at survey stage rather than on fitting day — walls get checked for wind and plumb, floors for level, and the setting-out is taken from the worst reading, not the best.
How we approach it
Every pair of hardwood gates we make starts with a site survey and a set of setting-out drawings, not a catalogue page. We measure the opening in North Yorkshire, check the walls for wind and the floor for fall, then cut a carcass that fits the room you actually have.
How we build it
Timber is chosen for the room it is going into. Painted work is built in tulipwood and moisture-resistant MDF because they hold a crisp arris and take a sprayed finish without grain rise. Where the grain is meant to be seen we use European oak, walnut or ash, with veneers laid so the figure runs continuously across a set of doors.
Finish and materials
Every finished job gets a short handover: what the surface is, how to clean it, and how to adjust a hinge if a door drops after the heating has been on for a season. Adjustment is normal in timber and takes about two minutes once you know which screw to turn.
| Guide price | from £1,450 per linear metre, fitted |
|---|---|
| Lead time | 6-8 weeks from signed drawings |
| Construction | Iroko, stainless ironmongery |
| Survey area | All of North Yorkshire, including York, Harrogate, Scarborough, Northallerton |
Want a number now? The indicative price tool gives a range in about a minute. A free survey in North Yorkshire turns it into a fixed written quote.
Towns we cover
Other joinery for North Yorkshire
What happens next
Four steps, no surprises
Survey
A joiner visits, measures the opening, checks for level and plumb, and talks through how you want to use the space.
Drawings & quote
You get a setting-out drawing and a fixed written price. Nothing is ordered until you have approved both.
Workshop
Parts are machined, assembled and finished under cover while the site carries on with other trades.
Fit & handover
We fit, scribe, adjust and touch in, then walk you through care and adjustment before we leave.
Straight answers
Hardwood Gates in North Yorkshire — common questions
What about a gap at the bottom?
Deliberate, and important. A gate closing tight to the ground wicks moisture into the bottom rail and will rot from there upward within a few years.
Which timber for gates?
Iroko or oak. Both are naturally durable enough for exterior use without pressure treatment. Iroko is more stable and less prone to staining around fixings.
Can gates be automated?
Yes, but the frame has to be built for it from the start — automation puts continuous load on the hinge stile. Retrofitting a motor to a gate not designed for it usually ends badly.
Do they need finishing?
Oil or leave to silver. Paint on an exterior gate needs more maintenance than most people expect, because the bottom rail is constantly wet.
What guarantee do you give?
Ten years on workmanship. Hardware carries the manufacturer's warranty, which on good runners and hinges is usually lifetime. Finishes are guaranteed for five years against flaking or delamination in normal domestic use.
Start with a measurement
Tell us the space in North Yorkshire — we’ll tell you what it costs
Every quote starts with a free measured survey, so the price you get is the price you pay. No deposit is taken until you have drawings you are happy with.