Home › Everything we make › Fascias & Signboards › Kent
Kent · South East
Fascias & Signboards in Kent
Signboard, cornice and blocking, sized to carry the signwriting properly.
- Free measured survey
- Fixed written quote
- Workshop-made, site-fitted
- 10-year workmanship guarantee
- Fully insured
Kent is a county of weatherboarded cottages, Victorian coastal terraces and large post-war suburbs. That is exactly the kind of building stock a shopfront fascia has to be drawn around, so we allow for it at survey stage rather than on fitting day — walls get checked for wind and plumb, floors for level, and the setting-out is taken from the worst reading, not the best.
How we approach it
Off-the-shelf units are made to standard sizes and then filled out with scribe strips. Our shopfront fascia work is cut to the dimensions taken from your Kent property, so there is no packing, no filler and no gap that opens up in year two.
How we build it
Timber is chosen for the room it is going into. Painted work is built in tulipwood and moisture-resistant MDF because they hold a crisp arris and take a sprayed finish without grain rise. Where the grain is meant to be seen we use European oak, walnut or ash, with veneers laid so the figure runs continuously across a set of doors.
Finish and materials
You can have it primed for your own decorator, sprayed in any RAL or heritage colour, or left in oiled timber. Oiled finishes can be refreshed at home; sprayed finishes are harder wearing and are what we recommend for kitchens and anything at knee height.
| Guide price | from £620 per linear metre, fitted |
|---|---|
| Lead time | 5-7 weeks from signed drawings |
| Construction | Accoya, painted |
| Survey area | All of Kent, including Maidstone, Canterbury, Tunbridge Wells, Ashford |
Want a number now? The indicative price tool gives a range in about a minute. A free survey in Kent turns it into a fixed written quote.
Towns we cover
Other joinery for Kent
What happens next
Four steps, no surprises
Survey
A joiner visits, measures the opening, checks for level and plumb, and talks through how you want to use the space.
Drawings & quote
You get a setting-out drawing and a fixed written price. Nothing is ordered until you have approved both.
Workshop
Parts are machined, assembled and finished under cover while the site carries on with other trades.
Fit & handover
We fit, scribe, adjust and touch in, then walk you through care and adjustment before we leave.
Straight answers
Fascias & Signboards in Kent — common questions
How is the fascia ventilated?
We leave a drained and ventilated cavity behind the board so any moisture that gets past the front face can dry. Sealing a fascia tight to the wall traps water against it.
How deep should a fascia be?
Deep enough that the signwriting has margin above and below — typically 350 to 500mm on a standard frontage. A shallow fascia forces cramped lettering and is the most common reason a new shopfront looks wrong.
What is the cornice for?
It throws water off the face of the fascia. Remove it and the signboard gets a permanent wet stripe. On a period frontage it is also the element that ties the shopfront to the building above.
What timber for a painted fascia?
Accoya. It holds paint far longer than softwood because it barely moves with humidity, and paint failure on a fascia is almost always the substrate moving underneath it.
Can you match existing joinery in the house?
Yes. We take a profile of the existing skirting, architrave or door and either match it from stock cutters or have a cutter ground so the new work runs identically. Matching an old paint colour is straightforward; matching aged oak takes a sample panel and a couple of attempts, which we build into the programme.
Start with a measurement
Tell us the space in Kent — we’ll tell you what it costs
Every quote starts with a free measured survey, so the price you get is the price you pay. No deposit is taken until you have drawings you are happy with.