Home › Everything we make › Shopfront Pilasters › Swansea
Swansea · Wales
Shopfront Pilasters in Swansea
The framing columns either side of the window, with plinth, shaft and capital.
- Free measured survey
- Fixed written quote
- Workshop-made, site-fitted
- 10-year workmanship guarantee
- Fully insured
Swansea is a county of stone and rendered terraces on steep ground, plus interwar suburban stock. That is exactly the kind of building stock a pair of shopfront pilasters has to be drawn around, so we allow for it at survey stage rather than on fitting day — walls get checked for wind and plumb, floors for level, and the setting-out is taken from the worst reading, not the best.
How we approach it
Every pair of shopfront pilasters we make starts with a site survey and a set of setting-out drawings, not a catalogue page. We measure the opening in Swansea, check the walls for wind and the floor for fall, then cut a carcass that fits the room you actually have.
How we build it
Carcass work is birch ply or MR MDF depending on span and load. Face frames and doors are solid hardwood. Everything is machined on the same setting so stiles, rails and reveals line through, and shadow gaps stay parallel from one end of the run to the other.
Finish and materials
Every finished job gets a short handover: what the surface is, how to clean it, and how to adjust a hinge if a door drops after the heating has been on for a season. Adjustment is normal in timber and takes about two minutes once you know which screw to turn.
| Guide price | from £890 per linear metre, fitted |
|---|---|
| Lead time | 6-8 weeks from signed drawings |
| Construction | Iroko, moulded and primed |
| Survey area | All of Swansea, including Swansea, Mumbles, Gorseinon, Morriston |
Want a number now? The indicative price tool gives a range in about a minute. A free survey in Swansea turns it into a fixed written quote.
Towns we cover
Other joinery for Swansea
What happens next
Four steps, no surprises
Survey
A joiner visits, measures the opening, checks for level and plumb, and talks through how you want to use the space.
Drawings & quote
You get a setting-out drawing and a fixed written price. Nothing is ordered until you have approved both.
Workshop
Parts are machined, assembled and finished under cover while the site carries on with other trades.
Fit & handover
We fit, scribe, adjust and touch in, then walk you through care and adjustment before we leave.
Straight answers
Shopfront Pilasters in Swansea — common questions
Are console brackets part of the pilaster?
They sit at the head of it and are usually quoted separately because the carving is a different operation. Fitted together they read as one element.
What is a pilaster?
The vertical framing column at each end of a shopfront. It carries the console bracket at the top and sits on a plinth at pavement level, and its proportions set how the whole frontage reads.
What size should a pilaster be?
It depends on the bay width and storey height rather than a standard. As a rule the pilaster reads too thin below about 200mm on a normal high-street bay. We set it off the elevation drawing so it looks deliberate.
What stops a pilaster rotting at the base?
A hardwood plinth, an end-grain seal, and a gap so it is not standing in water. Most failures are end grain wicking moisture off wet pavement, which is a detailing problem, not a timber problem.
Do I need to empty the room before you fit?
Clear the working wall and anything fragile. We bring dust sheets and a vacuum-extracted saw, but fitting makes dust and we would rather your furniture was out of the way. For kitchens we will agree a sequence with you so you keep a sink and a kettle for as long as possible.
Start with a measurement
Tell us the space in Swansea — we’ll tell you what it costs
Every quote starts with a free measured survey, so the price you get is the price you pay. No deposit is taken until you have drawings you are happy with.