Home › Everything we make › Staircases & Balustrades › Hampshire
Hampshire · South East
Staircases & Balustrades in Hampshire
Cut string or closed string stairs, handrails and spindles to Part K.
- Free measured survey
- Fixed written quote
- Workshop-made, site-fitted
- 10-year workmanship guarantee
- Fully insured
Hampshire is a county of Georgian naval-town housing, thatched village cottages and extensive modern estates. That is exactly the kind of building stock a staircase has to be drawn around, so we allow for it at survey stage rather than on fitting day — walls get checked for wind and plumb, floors for level, and the setting-out is taken from the worst reading, not the best.
How we approach it
Every staircase we make starts with a site survey and a set of setting-out drawings, not a catalogue page. We measure the opening in Hampshire, check the walls for wind and the floor for fall, then cut a carcass that fits the room you actually have.
How we build it
Hardware is specified to the weight it is carrying, not to a price point. Soft-close runners are rated for the drawer load, hinges are adjustable in three planes, and sliding gear is sized so a full-height door still moves with one finger a decade later.
Finish and materials
Every finished job gets a short handover: what the surface is, how to clean it, and how to adjust a hinge if a door drops after the heating has been on for a season. Adjustment is normal in timber and takes about two minutes once you know which screw to turn.
| Guide price | from £2,400 per linear metre, fitted |
|---|---|
| Lead time | 8–12 weeks from signed drawings |
| Construction | Oak or paint-grade |
| Survey area | All of Hampshire, including Southampton, Portsmouth, Winchester, Basingstoke |
Want a number now? The indicative price tool gives a range in about a minute. A free survey in Hampshire turns it into a fixed written quote.
Towns we cover
Other joinery for Hampshire
What happens next
Four steps, no surprises
Survey
A joiner visits, measures the opening, checks for level and plumb, and talks through how you want to use the space.
Drawings & quote
You get a setting-out drawing and a fixed written price. Nothing is ordered until you have approved both.
Workshop
Parts are machined, assembled and finished under cover while the site carries on with other trades.
Fit & handover
We fit, scribe, adjust and touch in, then walk you through care and adjustment before we leave.
Straight answers
Staircases & Balustrades in Hampshire — common questions
Can the space under the new stair be used?
Yes, and it should be designed in from the start rather than added later. See our under-stairs storage service.
Do stairs have to meet building regulations?
Yes — Part K in England and Wales. The main constraints are a maximum 42-degree pitch, a minimum 190mm going, a maximum 220mm rise, 2,000mm headroom, and a 100mm sphere rule that no gap in the balustrade may pass. We design to these as standard.
What is a cut string stair?
One where the outer string is cut to the profile of the treads so each tread end is visible, usually with a scotia moulding beneath. It is the more refined, traditional detail. A closed string hides the tread ends behind a solid board and is simpler and cheaper.
Will the stairs creak?
Not when new. Creaks come from movement between the tread and the riser as the timber shrinks. We glue and block every tread-riser joint and wedge the housings, which is what prevents it.
Do you work with architects and builders?
Regularly. We can work to your drawings and specification, price from a schedule, and co-ordinate with the main contractor's programme. We are equally happy dealing directly with a homeowner from a rough sketch.
Start with a measurement
Tell us the space in Hampshire — we’ll tell you what it costs
Every quote starts with a free measured survey, so the price you get is the price you pay. No deposit is taken until you have drawings you are happy with.