Home › Everything we make › Timber Cladding › Hertfordshire
Hertfordshire · East
Timber Cladding in Hertfordshire
Larch, cedar or thermowood rainscreen on a ventilated batten cavity.
- Free measured survey
- Fixed written quote
- Workshop-made, site-fitted
- 10-year workmanship guarantee
- Fully insured
Hertfordshire is a county of garden-city housing, Georgian market-town centres and generous 1960s detached stock. That is exactly the kind of building stock a run of timber cladding has to be drawn around, so we allow for it at survey stage rather than on fitting day — walls get checked for wind and plumb, floors for level, and the setting-out is taken from the worst reading, not the best.
How we approach it
Every run of timber cladding we make starts with a site survey and a set of setting-out drawings, not a catalogue page. We measure the opening in Hertfordshire, check the walls for wind and the floor for fall, then cut a carcass that fits the room you actually have.
How we build it
Hardware is specified to the weight it is carrying, not to a price point. Soft-close runners are rated for the drawer load, hinges are adjustable in three planes, and sliding gear is sized so a full-height door still moves with one finger a decade later.
Finish and materials
Every finished job gets a short handover: what the surface is, how to clean it, and how to adjust a hinge if a door drops after the heating has been on for a season. Adjustment is normal in timber and takes about two minutes once you know which screw to turn.
| Guide price | from £190 per linear metre, fitted |
|---|---|
| Lead time | 3–5 weeks from signed drawings |
| Construction | Siberian larch |
| Survey area | All of Hertfordshire, including St Albans, Watford, Hemel Hempstead, Stevenage |
Want a number now? The indicative price tool gives a range in about a minute. A free survey in Hertfordshire turns it into a fixed written quote.
Towns we cover
Other joinery for Hertfordshire
What happens next
Four steps, no surprises
Survey
A joiner visits, measures the opening, checks for level and plumb, and talks through how you want to use the space.
Drawings & quote
You get a setting-out drawing and a fixed written price. Nothing is ordered until you have approved both.
Workshop
Parts are machined, assembled and finished under cover while the site carries on with other trades.
Fit & handover
We fit, scribe, adjust and touch in, then walk you through care and adjustment before we leave.
Straight answers
Timber Cladding in Hertfordshire — common questions
Can I clad over existing render or brick?
Yes, provided the substrate is sound and the wall can take the batten fixings. It is a common way to update a tired elevation and adds a ventilated layer that helps the wall dry.
Which timber should I use for cladding?
Siberian larch for durability and value; western red cedar for stability and a finer grain at a higher price; thermowood for good dimensional stability on a budget. All three can be left to silver or kept in colour with a UV-stable oil.
How is it fixed?
Stainless steel ring-shank nails or screws — never galvanised, which reacts with the tannin in larch and cedar and leaves black streaks down the elevation. Secret-fixed profiles are available where you want no visible fixings.
What board profile should I choose?
Shiplap and feather edge are traditional and shed water well. Square-edge with a shadow gap reads contemporary and needs a good membrane behind it because it is not weather-tight on its own. Vertical boards drain faster than horizontal.
Do you work with architects and builders?
Regularly. We can work to your drawings and specification, price from a schedule, and co-ordinate with the main contractor's programme. We are equally happy dealing directly with a homeowner from a rough sketch.
Start with a measurement
Tell us the space in Hertfordshire — we’ll tell you what it costs
Every quote starts with a free measured survey, so the price you get is the price you pay. No deposit is taken until you have drawings you are happy with.