Home › Everything we make › Hardwood Worktops › Ayrshire
Ayrshire · Scotland
Hardwood Worktops in Ayrshire
Solid and staved tops, templated on site and jointed dry.
- Free measured survey
- Fixed written quote
- Workshop-made, site-fitted
- 10-year workmanship guarantee
- Fully insured
Ayrshire is a county of sandstone terraces, coastal Victorian villas and rural farm properties. That is exactly the kind of building stock a run of hardwood worktop has to be drawn around, so we allow for it at survey stage rather than on fitting day — walls get checked for wind and plumb, floors for level, and the setting-out is taken from the worst reading, not the best.
How we approach it
We build hardwood worktops as cabinetmakers rather than fitters: machined joints, real carcass construction, and a finish applied under workshop conditions before anything reaches your Ayrshire address.
How we build it
Timber is chosen for the room it is going into. Painted work is built in tulipwood and moisture-resistant MDF because they hold a crisp arris and take a sprayed finish without grain rise. Where the grain is meant to be seen we use European oak, walnut or ash, with veneers laid so the figure runs continuously across a set of doors.
Finish and materials
Finishing happens in the workshop wherever possible. Sprayed paint gives an even film that brushwork cannot match, and the only work left on site is the final touch-in around scribes and fixings.
| Guide price | from £780 per linear metre, fitted |
|---|---|
| Lead time | 4-6 weeks from signed drawings |
| Construction | Staved oak or iroko, oiled |
| Survey area | All of Ayrshire, including Ayr, Kilmarnock, Irvine, Troon |
Want a number now? The indicative price tool gives a range in about a minute. A free survey in Ayrshire turns it into a fixed written quote.
Towns we cover
Other joinery for Ayrshire
What happens next
Four steps, no surprises
Survey
A joiner visits, measures the opening, checks for level and plumb, and talks through how you want to use the space.
Drawings & quote
You get a setting-out drawing and a fixed written price. Nothing is ordered until you have approved both.
Workshop
Parts are machined, assembled and finished under cover while the site carries on with other trades.
Fit & handover
We fit, scribe, adjust and touch in, then walk you through care and adjustment before we leave.
Straight answers
Hardwood Worktops in Ayrshire — common questions
How are joints made?
Dry-jointed with connectors so the timber can move, not glued solid. A glued butt joint across the grain in a kitchen will open.
Solid or staved?
Staved — narrow strips glued up — is more stable and far less likely to cup than a wide solid board. Full-stave gives a longer, cleaner grain line; narrow stave is more economical.
Can I have a sink cut into it?
Yes. Undermount needs the cut edge sealing very thoroughly — that edge is the most common failure point on any timber top. We seal it before the sink goes anywhere near it.
Will it mark?
Yes, and it will develop a patina. That is the trade-off for a surface you can repair rather than replace. If unmarked is the requirement, timber is the wrong material.
Can you match existing joinery in the house?
Yes. We take a profile of the existing skirting, architrave or door and either match it from stock cutters or have a cutter ground so the new work runs identically. Matching an old paint colour is straightforward; matching aged oak takes a sample panel and a couple of attempts, which we build into the programme.
Start with a measurement
Tell us the space in Ayrshire — we’ll tell you what it costs
Every quote starts with a free measured survey, so the price you get is the price you pay. No deposit is taken until you have drawings you are happy with.