Home › Everything we make › Hardwood Worktops › Perth and Kinross
Perth and Kinross · Scotland
Hardwood Worktops in Perth and Kinross
Solid and staved tops, templated on site and jointed dry.
- Free measured survey
- Fixed written quote
- Workshop-made, site-fitted
- 10-year workmanship guarantee
- Fully insured
Perth and Kinross is a county of stone-built town houses and rural steadings with substantial period joinery. That is exactly the kind of building stock a run of hardwood worktop has to be drawn around, so we allow for it at survey stage rather than on fitting day — walls get checked for wind and plumb, floors for level, and the setting-out is taken from the worst reading, not the best.
How we approach it
We build hardwood worktops as cabinetmakers rather than fitters: machined joints, real carcass construction, and a finish applied under workshop conditions before anything reaches your Perth and Kinross address.
How we build it
Hardware is specified to the weight it is carrying, not to a price point. Soft-close runners are rated for the drawer load, hinges are adjustable in three planes, and sliding gear is sized so a full-height door still moves with one finger a decade later.
Finish and materials
Every finished job gets a short handover: what the surface is, how to clean it, and how to adjust a hinge if a door drops after the heating has been on for a season. Adjustment is normal in timber and takes about two minutes once you know which screw to turn.
| Guide price | from £780 per linear metre, fitted |
|---|---|
| Lead time | 4-6 weeks from signed drawings |
| Construction | Staved oak or iroko, oiled |
| Survey area | All of Perth and Kinross, including Perth, Crieff, Blairgowrie, Pitlochry |
Want a number now? The indicative price tool gives a range in about a minute. A free survey in Perth and Kinross turns it into a fixed written quote.
Towns we cover
Other joinery for Perth and Kinross
What happens next
Four steps, no surprises
Survey
A joiner visits, measures the opening, checks for level and plumb, and talks through how you want to use the space.
Drawings & quote
You get a setting-out drawing and a fixed written price. Nothing is ordered until you have approved both.
Workshop
Parts are machined, assembled and finished under cover while the site carries on with other trades.
Fit & handover
We fit, scribe, adjust and touch in, then walk you through care and adjustment before we leave.
Straight answers
Hardwood Worktops in Perth and Kinross — common questions
Solid or staved?
Staved — narrow strips glued up — is more stable and far less likely to cup than a wide solid board. Full-stave gives a longer, cleaner grain line; narrow stave is more economical.
Can I have a sink cut into it?
Yes. Undermount needs the cut edge sealing very thoroughly — that edge is the most common failure point on any timber top. We seal it before the sink goes anywhere near it.
Will it mark?
Yes, and it will develop a patina. That is the trade-off for a surface you can repair rather than replace. If unmarked is the requirement, timber is the wrong material.
How are joints made?
Dry-jointed with connectors so the timber can move, not glued solid. A glued butt joint across the grain in a kitchen will open.
Do I need to empty the room before you fit?
Clear the working wall and anything fragile. We bring dust sheets and a vacuum-extracted saw, but fitting makes dust and we would rather your furniture was out of the way. For kitchens we will agree a sequence with you so you keep a sink and a kettle for as long as possible.
Start with a measurement
Tell us the space in Perth and Kinross — we’ll tell you what it costs
Every quote starts with a free measured survey, so the price you get is the price you pay. No deposit is taken until you have drawings you are happy with.