Home › Everything we make › Stallrisers › Dundee and Angus
Dundee and Angus · Scotland
Stallrisers in Dundee and Angus
The panelled base below the display glass, where the knocks actually land.
- Free measured survey
- Fixed written quote
- Workshop-made, site-fitted
- 10-year workmanship guarantee
- Fully insured
Dundee and Angus is a county of sandstone tenements, jute-era terraces and coastal town housing. That is exactly the kind of building stock a stallriser has to be drawn around, so we allow for it at survey stage rather than on fitting day — walls get checked for wind and plumb, floors for level, and the setting-out is taken from the worst reading, not the best.
How we approach it
Off-the-shelf units are made to standard sizes and then filled out with scribe strips. Our stallriser work is cut to the dimensions taken from your Dundee and Angus property, so there is no packing, no filler and no gap that opens up in year two.
How we build it
Hardware is specified to the weight it is carrying, not to a price point. Soft-close runners are rated for the drawer load, hinges are adjustable in three planes, and sliding gear is sized so a full-height door still moves with one finger a decade later.
Finish and materials
Every finished job gets a short handover: what the surface is, how to clean it, and how to adjust a hinge if a door drops after the heating has been on for a season. Adjustment is normal in timber and takes about two minutes once you know which screw to turn.
| Guide price | from £540 per linear metre, fitted |
|---|---|
| Lead time | 5-7 weeks from signed drawings |
| Construction | Iroko frame, moisture-tolerant panel |
| Survey area | All of Dundee and Angus, including Dundee, Arbroath, Montrose, Forfar |
Want a number now? The indicative price tool gives a range in about a minute. A free survey in Dundee and Angus turns it into a fixed written quote.
Towns we cover
Other joinery for Dundee and Angus
What happens next
Four steps, no surprises
Survey
A joiner visits, measures the opening, checks for level and plumb, and talks through how you want to use the space.
Drawings & quote
You get a setting-out drawing and a fixed written price. Nothing is ordered until you have approved both.
Workshop
Parts are machined, assembled and finished under cover while the site carries on with other trades.
Fit & handover
We fit, scribe, adjust and touch in, then walk you through care and adjustment before we leave.
Straight answers
Stallrisers in Dundee and Angus — common questions
How is it finished?
All faces sealed, including the back and the bottom edge, before it goes near the wall. The bottom edge is the one everyone forgets and the one that fails.
How tall should it be?
Usually 450 to 750mm. Too low and the glass takes the damage; too high and the display disappears from view. On a parade we generally match the neighbours so the run reads evenly.
Can a stallriser be repaired in sections?
Yes, and it usually is. The panel nearest the door goes first. We replace panels within the existing frame where the frame is sound.
Can you match a fielded panel profile?
Yes, from a gauge taken off the original. Fielded, flat and bolection panels all read differently and it is obvious when the wrong one is used.
How long does a bespoke job take from order to fitting?
Most fitted furniture runs four to eight weeks from approved drawings to fitting day. Kitchens, staircases and timber windows are longer at eight to fourteen weeks because the components are larger and the finishing schedule is longer. We give you a date band at quotation and confirm the fitting week once the drawings are signed off.
Start with a measurement
Tell us the space in Dundee and Angus — we’ll tell you what it costs
Every quote starts with a free measured survey, so the price you get is the price you pay. No deposit is taken until you have drawings you are happy with.