Home › Everything we make › Stallrisers › Greater London
Greater London · London
Stallrisers in Greater London
The panelled base below the display glass, where the knocks actually land.
- Free measured survey
- Fixed written quote
- Workshop-made, site-fitted
- 10-year workmanship guarantee
- Fully insured
Greater London is a county of Victorian and Edwardian terraces, Georgian townhouses and post-war conversions, where no two chimney alcoves are the same width. That is exactly the kind of building stock a stallriser has to be drawn around, so we allow for it at survey stage rather than on fitting day — walls get checked for wind and plumb, floors for level, and the setting-out is taken from the worst reading, not the best.
How we approach it
A stallriser is a permanent part of the building, so it is worth setting out properly. We take the survey, agree the drawings, machine the parts in the workshop and fit in Greater London in one visit wherever the programme allows.
How we build it
Timber is chosen for the room it is going into. Painted work is built in tulipwood and moisture-resistant MDF because they hold a crisp arris and take a sprayed finish without grain rise. Where the grain is meant to be seen we use European oak, walnut or ash, with veneers laid so the figure runs continuously across a set of doors.
Finish and materials
You can have it primed for your own decorator, sprayed in any RAL or heritage colour, or left in oiled timber. Oiled finishes can be refreshed at home; sprayed finishes are harder wearing and are what we recommend for kitchens and anything at knee height.
| Guide price | from £540 per linear metre, fitted |
|---|---|
| Lead time | 5-7 weeks from signed drawings |
| Construction | Iroko frame, moisture-tolerant panel |
| Survey area | All of Greater London, including Camden, Islington, Hackney, Wandsworth |
Want a number now? The indicative price tool gives a range in about a minute. A free survey in Greater London turns it into a fixed written quote.
Towns we cover
Other joinery for Greater London
What happens next
Four steps, no surprises
Survey
A joiner visits, measures the opening, checks for level and plumb, and talks through how you want to use the space.
Drawings & quote
You get a setting-out drawing and a fixed written price. Nothing is ordered until you have approved both.
Workshop
Parts are machined, assembled and finished under cover while the site carries on with other trades.
Fit & handover
We fit, scribe, adjust and touch in, then walk you through care and adjustment before we leave.
Straight answers
Stallrisers in Greater London — common questions
How tall should it be?
Usually 450 to 750mm. Too low and the glass takes the damage; too high and the display disappears from view. On a parade we generally match the neighbours so the run reads evenly.
Can a stallriser be repaired in sections?
Yes, and it usually is. The panel nearest the door goes first. We replace panels within the existing frame where the frame is sound.
Can you match a fielded panel profile?
Yes, from a gauge taken off the original. Fielded, flat and bolection panels all read differently and it is obvious when the wrong one is used.
How is it finished?
All faces sealed, including the back and the bottom edge, before it goes near the wall. The bottom edge is the one everyone forgets and the one that fails.
Is bespoke joinery more expensive than a fitted furniture chain?
On a like-for-like specification it is usually comparable, and often less. Chains price a standard carcass and then charge for every deviation. A bespoke maker prices the actual room once. Where bespoke does cost more is in the materials — solid hardwood and sprayed finishes cost more than foil-wrapped board, and they last a great deal longer.
Start with a measurement
Tell us the space in Greater London — we’ll tell you what it costs
Every quote starts with a free measured survey, so the price you get is the price you pay. No deposit is taken until you have drawings you are happy with.