Home › Everything we make › Stallrisers › Merseyside
Merseyside · North West
Stallrisers in Merseyside
The panelled base below the display glass, where the knocks actually land.
- Free measured survey
- Fixed written quote
- Workshop-made, site-fitted
- 10-year workmanship guarantee
- Fully insured
Merseyside is a county of Georgian and Victorian townhouses, terraced streets and post-war regeneration stock. That is exactly the kind of building stock a stallriser has to be drawn around, so we allow for it at survey stage rather than on fitting day — walls get checked for wind and plumb, floors for level, and the setting-out is taken from the worst reading, not the best.
How we approach it
Every stallriser we make starts with a site survey and a set of setting-out drawings, not a catalogue page. We measure the opening in Merseyside, check the walls for wind and the floor for fall, then cut a carcass that fits the room you actually have.
How we build it
Moisture matters more than most people expect. Timber is conditioned before machining, and anything going into a kitchen, utility or bathroom is specified in materials that will not swell at the bottom edge. That is why the base of a well-made unit still closes cleanly after five winters.
Finish and materials
You can have it primed for your own decorator, sprayed in any RAL or heritage colour, or left in oiled timber. Oiled finishes can be refreshed at home; sprayed finishes are harder wearing and are what we recommend for kitchens and anything at knee height.
| Guide price | from £540 per linear metre, fitted |
|---|---|
| Lead time | 5-7 weeks from signed drawings |
| Construction | Iroko frame, moisture-tolerant panel |
| Survey area | All of Merseyside, including Liverpool, St Helens, Southport, Birkenhead |
Want a number now? The indicative price tool gives a range in about a minute. A free survey in Merseyside turns it into a fixed written quote.
Towns we cover
Other joinery for Merseyside
What happens next
Four steps, no surprises
Survey
A joiner visits, measures the opening, checks for level and plumb, and talks through how you want to use the space.
Drawings & quote
You get a setting-out drawing and a fixed written price. Nothing is ordered until you have approved both.
Workshop
Parts are machined, assembled and finished under cover while the site carries on with other trades.
Fit & handover
We fit, scribe, adjust and touch in, then walk you through care and adjustment before we leave.
Straight answers
Stallrisers in Merseyside — common questions
Can you match a fielded panel profile?
Yes, from a gauge taken off the original. Fielded, flat and bolection panels all read differently and it is obvious when the wrong one is used.
How is it finished?
All faces sealed, including the back and the bottom edge, before it goes near the wall. The bottom edge is the one everyone forgets and the one that fails.
How tall should it be?
Usually 450 to 750mm. Too low and the glass takes the damage; too high and the display disappears from view. On a parade we generally match the neighbours so the run reads evenly.
Can a stallriser be repaired in sections?
Yes, and it usually is. The panel nearest the door goes first. We replace panels within the existing frame where the frame is sound.
How do I pay, and when?
A deposit at order to cover materials, a stage payment when the work leaves the workshop, and the balance on completion after you have inspected the fit. Everything is written into the quotation before you commit.
Start with a measurement
Tell us the space in Merseyside — we’ll tell you what it costs
Every quote starts with a free measured survey, so the price you get is the price you pay. No deposit is taken until you have drawings you are happy with.