Home › Everything we make › Stallrisers › Pembrokeshire
Pembrokeshire · Wales
Stallrisers in Pembrokeshire
The panelled base below the display glass, where the knocks actually land.
- Free measured survey
- Fixed written quote
- Workshop-made, site-fitted
- 10-year workmanship guarantee
- Fully insured
Pembrokeshire is a county of rendered stone cottages, coastal second homes and exposed weather conditions. That is exactly the kind of building stock a stallriser has to be drawn around, so we allow for it at survey stage rather than on fitting day — walls get checked for wind and plumb, floors for level, and the setting-out is taken from the worst reading, not the best.
How we approach it
Every stallriser we make starts with a site survey and a set of setting-out drawings, not a catalogue page. We measure the opening in Pembrokeshire, check the walls for wind and the floor for fall, then cut a carcass that fits the room you actually have.
How we build it
Carcass work is birch ply or MR MDF depending on span and load. Face frames and doors are solid hardwood. Everything is machined on the same setting so stiles, rails and reveals line through, and shadow gaps stay parallel from one end of the run to the other.
Finish and materials
Every finished job gets a short handover: what the surface is, how to clean it, and how to adjust a hinge if a door drops after the heating has been on for a season. Adjustment is normal in timber and takes about two minutes once you know which screw to turn.
| Guide price | from £540 per linear metre, fitted |
|---|---|
| Lead time | 5-7 weeks from signed drawings |
| Construction | Iroko frame, moisture-tolerant panel |
| Survey area | All of Pembrokeshire, including Haverfordwest, Tenby, Pembroke, Milford Haven |
Want a number now? The indicative price tool gives a range in about a minute. A free survey in Pembrokeshire turns it into a fixed written quote.
Towns we cover
Other joinery for Pembrokeshire
What happens next
Four steps, no surprises
Survey
A joiner visits, measures the opening, checks for level and plumb, and talks through how you want to use the space.
Drawings & quote
You get a setting-out drawing and a fixed written price. Nothing is ordered until you have approved both.
Workshop
Parts are machined, assembled and finished under cover while the site carries on with other trades.
Fit & handover
We fit, scribe, adjust and touch in, then walk you through care and adjustment before we leave.
Straight answers
Stallrisers in Pembrokeshire — common questions
Can a stallriser be repaired in sections?
Yes, and it usually is. The panel nearest the door goes first. We replace panels within the existing frame where the frame is sound.
Can you match a fielded panel profile?
Yes, from a gauge taken off the original. Fielded, flat and bolection panels all read differently and it is obvious when the wrong one is used.
How is it finished?
All faces sealed, including the back and the bottom edge, before it goes near the wall. The bottom edge is the one everyone forgets and the one that fails.
How tall should it be?
Usually 450 to 750mm. Too low and the glass takes the damage; too high and the display disappears from view. On a parade we generally match the neighbours so the run reads evenly.
Is bespoke joinery more expensive than a fitted furniture chain?
On a like-for-like specification it is usually comparable, and often less. Chains price a standard carcass and then charge for every deviation. A bespoke maker prices the actual room once. Where bespoke does cost more is in the materials — solid hardwood and sprayed finishes cost more than foil-wrapped board, and they last a great deal longer.
Start with a measurement
Tell us the space in Pembrokeshire — we’ll tell you what it costs
Every quote starts with a free measured survey, so the price you get is the price you pay. No deposit is taken until you have drawings you are happy with.