Home › Everything we make › Stallrisers › Wiltshire
Wiltshire · South West
Stallrisers in Wiltshire
The panelled base below the display glass, where the knocks actually land.
- Free measured survey
- Fixed written quote
- Workshop-made, site-fitted
- 10-year workmanship guarantee
- Fully insured
Wiltshire is a county of chalk and flint cottages, Georgian market-town stock and large garrison housing areas. That is exactly the kind of building stock a stallriser has to be drawn around, so we allow for it at survey stage rather than on fitting day — walls get checked for wind and plumb, floors for level, and the setting-out is taken from the worst reading, not the best.
How we approach it
We build stallrisers as cabinetmakers rather than fitters: machined joints, real carcass construction, and a finish applied under workshop conditions before anything reaches your Wiltshire address.
How we build it
Moisture matters more than most people expect. Timber is conditioned before machining, and anything going into a kitchen, utility or bathroom is specified in materials that will not swell at the bottom edge. That is why the base of a well-made unit still closes cleanly after five winters.
Finish and materials
You can have it primed for your own decorator, sprayed in any RAL or heritage colour, or left in oiled timber. Oiled finishes can be refreshed at home; sprayed finishes are harder wearing and are what we recommend for kitchens and anything at knee height.
| Guide price | from £540 per linear metre, fitted |
|---|---|
| Lead time | 5-7 weeks from signed drawings |
| Construction | Iroko frame, moisture-tolerant panel |
| Survey area | All of Wiltshire, including Swindon, Salisbury, Chippenham, Trowbridge |
Want a number now? The indicative price tool gives a range in about a minute. A free survey in Wiltshire turns it into a fixed written quote.
Towns we cover
Other joinery for Wiltshire
What happens next
Four steps, no surprises
Survey
A joiner visits, measures the opening, checks for level and plumb, and talks through how you want to use the space.
Drawings & quote
You get a setting-out drawing and a fixed written price. Nothing is ordered until you have approved both.
Workshop
Parts are machined, assembled and finished under cover while the site carries on with other trades.
Fit & handover
We fit, scribe, adjust and touch in, then walk you through care and adjustment before we leave.
Straight answers
Stallrisers in Wiltshire — common questions
Can you match a fielded panel profile?
Yes, from a gauge taken off the original. Fielded, flat and bolection panels all read differently and it is obvious when the wrong one is used.
How is it finished?
All faces sealed, including the back and the bottom edge, before it goes near the wall. The bottom edge is the one everyone forgets and the one that fails.
How tall should it be?
Usually 450 to 750mm. Too low and the glass takes the damage; too high and the display disappears from view. On a parade we generally match the neighbours so the run reads evenly.
Can a stallriser be repaired in sections?
Yes, and it usually is. The panel nearest the door goes first. We replace panels within the existing frame where the frame is sound.
Can you match existing joinery in the house?
Yes. We take a profile of the existing skirting, architrave or door and either match it from stock cutters or have a cutter ground so the new work runs identically. Matching an old paint colour is straightforward; matching aged oak takes a sample panel and a couple of attempts, which we build into the programme.
Start with a measurement
Tell us the space in Wiltshire — we’ll tell you what it costs
Every quote starts with a free measured survey, so the price you get is the price you pay. No deposit is taken until you have drawings you are happy with.