Home › Everything we make › Hardwood Worktops › Essex
Essex · East
Hardwood Worktops in Essex
Solid and staved tops, templated on site and jointed dry.
- Free measured survey
- Fixed written quote
- Workshop-made, site-fitted
- 10-year workmanship guarantee
- Fully insured
Essex is a county of timber-framed cottages inland and interwar and modern estates along the Thames corridor. That is exactly the kind of building stock a run of hardwood worktop has to be drawn around, so we allow for it at survey stage rather than on fitting day — walls get checked for wind and plumb, floors for level, and the setting-out is taken from the worst reading, not the best.
How we approach it
Every run of hardwood worktop we make starts with a site survey and a set of setting-out drawings, not a catalogue page. We measure the opening in Essex, check the walls for wind and the floor for fall, then cut a carcass that fits the room you actually have.
How we build it
Moisture matters more than most people expect. Timber is conditioned before machining, and anything going into a kitchen, utility or bathroom is specified in materials that will not swell at the bottom edge. That is why the base of a well-made unit still closes cleanly after five winters.
Finish and materials
You can have it primed for your own decorator, sprayed in any RAL or heritage colour, or left in oiled timber. Oiled finishes can be refreshed at home; sprayed finishes are harder wearing and are what we recommend for kitchens and anything at knee height.
| Guide price | from £780 per linear metre, fitted |
|---|---|
| Lead time | 4-6 weeks from signed drawings |
| Construction | Staved oak or iroko, oiled |
| Survey area | All of Essex, including Chelmsford, Colchester, Southend-on-Sea, Basildon |
Want a number now? The indicative price tool gives a range in about a minute. A free survey in Essex turns it into a fixed written quote.
Towns we cover
Other joinery for Essex
What happens next
Four steps, no surprises
Survey
A joiner visits, measures the opening, checks for level and plumb, and talks through how you want to use the space.
Drawings & quote
You get a setting-out drawing and a fixed written price. Nothing is ordered until you have approved both.
Workshop
Parts are machined, assembled and finished under cover while the site carries on with other trades.
Fit & handover
We fit, scribe, adjust and touch in, then walk you through care and adjustment before we leave.
Straight answers
Hardwood Worktops in Essex — common questions
Can I have a sink cut into it?
Yes. Undermount needs the cut edge sealing very thoroughly — that edge is the most common failure point on any timber top. We seal it before the sink goes anywhere near it.
Will it mark?
Yes, and it will develop a patina. That is the trade-off for a surface you can repair rather than replace. If unmarked is the requirement, timber is the wrong material.
How are joints made?
Dry-jointed with connectors so the timber can move, not glued solid. A glued butt joint across the grain in a kitchen will open.
Solid or staved?
Staved — narrow strips glued up — is more stable and far less likely to cup than a wide solid board. Full-stave gives a longer, cleaner grain line; narrow stave is more economical.
What guarantee do you give?
Ten years on workmanship. Hardware carries the manufacturer's warranty, which on good runners and hinges is usually lifetime. Finishes are guaranteed for five years against flaking or delamination in normal domestic use.
Start with a measurement
Tell us the space in Essex — we’ll tell you what it costs
Every quote starts with a free measured survey, so the price you get is the price you pay. No deposit is taken until you have drawings you are happy with.